Redmi 2 Model 2014818 Flash done OR After Flash Hang on Logo Solution (Tested)

I had a Redmi 2 (Model 2014818) with an issue where the phone was stuck on the logo and would not boot further. I tried flashing different stock ROM firmwares, but none of them worked. After searching on the internet, I found a new solution. At first, I was not sure if it would work, but I decided to try it.

Surprisingly, the solution worked within a few seconds. It was really an amazing fix. There was no need to flash the device again and no need to download any new firmware. You only need to connect the device in Fastboot mode and run a simple command in the Command Prompt.

If you face a similar issue, you can try this solution. However, before trying it, make sure to read all the comments and instructions carefully. In some cases, people reported problems when they did not follow the steps properly. Always try the solution step by step to avoid any risk of dead boot or other issues.

Below is some information about the firmware.

The Redmi 2 Model 2014818 flash file mentioned here has been tested by me and works without any errors. You can use this flash file if your device is stuck on the logo, restarting continuously, locked with a security lock, password lock, pattern lock, or has any other software-related problems.

This flashing method does not require any flashing box and is completely free for users who have basic knowledge of mobile software flashing.

Important notes before flashing:

1. Check your micro USB cable. If it is faulty, flashing may fail.

2. Make sure your device battery is sufficiently charged. A low battery can interrupt the flashing process and cause serious problems.

3. Back up all important data such as contacts, photos, and videos. This is a factory flash file, and all data will be erased after flashing.

Please remember all these important points before starting the flashing process.

Download Link

(Tested) Xiaomi 2014818 Stock ROM Download | Mirror | Volte ROM

Xiaomi 2014818 MiFlash tool

Xiaomi 2014818 USB Flashing Driver

Required for flash:

• Xiaomi 2014818 device with good battery charged
• Xiaomi 2014818 tested firmware
• MiFlash tool
• Xiaomi 2014818 USB flashing driver
• Micro USB cable
• Computer or Laptop

Procedure:

• Take tested Stock ROM firmware from above link (plz if link dead just leave your comment)
• Go to Firmware winrar and please rename to .tgz, if is .gz or tar
• Extract to desktop both winrar (Note : Must your firmware folder in desktop)
• Open Mi folder and choose MiFlash.exe file and open it
• Click on Browse button and choose firmware folder who in desktop (see below image)

• Click on Point button near browse button and choose Advance option (see below image)

• Choose Browse.. button to FastBoot script's and choose flash_all_except_data_storage.bat file from desktop firmware folder (see below image)

• Turn off device, Press the Volume Down + Power keys same time for enter Fastboot mode

• Attach Micro usb cable and click on Refresh button in flash tool (for device detect or not)
• If device detect with flash tool then click on Flash button
• Wait until driver install, if driver installed in computer or laptop then downloading automatically start
• Wait until full flash device
• Congratulation you are done

Redmi 2 Model 2014818 Flash done Screenshot:

Redmi 2 Model 2014818 Flash done Video

How to Solve After Hang on Logo device ?

• Turn off device and take out battery into device
• Insert battery into device 
• Press the Volume Down + Power keys same time for enter Fastboot mode

• Insert usb cable into device
• Go to C:\Program Files\Mi Flash tool\Google\Android
• Press SHIFT Key and Right click and choose open command window here
• Type : fastboot -w and Hit Enter key
• Type : fastboot reboot and Hit Enter key
• Congratulation you are done

Redmi 2 Model 2014818 Hang on logo Video done

Note : if any query using this tutorial just leave your comment i will soon reply.