Have you accidentally bricked your Redmi Note 5 Pro? Don’t worry — you’re not alone. Many users end up in this situation while flashing custom ROMs, rooting, or during software updates. The good news? In most cases, your Redmi Note 5 Pro isn’t truly dead — it can be unbricked and brought back to life.
In this article, we’ll walk you through easy and effective steps to unbrick Redmi Note 5 Pro and get your phone working like new again.
🔍 What Does Redmi Note 5 Pro "Bricked" Mean?
Before we dive into the process, let’s quickly understand what a bricked phone means.
- A soft-brick usually happens when your device gets stuck in a boot loop or freezes at the Mi logo. It’s software-related and easier to fix.
- A hard-brick is more serious — your phone shows no sign of life, doesn’t charge, and isn’t recognized by your computer.
Fortunately, both can be fixed with the right tools and patience.
🧩 Can’t Access Fastboot? Try EDL Mode
If Fastboot mode isn't working, you may need to use EDL (Emergency Download) Mode. This requires additional tools like Test Points or a deep flash cable. It’s a bit technical, so proceed only if you’re confident — or seek help from a technician.
Unbricking your Redmi Note 5 Pro might seem intimidating, but with the right method, it’s totally doable. Just follow the steps carefully, and you’ll likely have your phone working again in under 30 minutes.
If you found this guide helpful, don’t forget to share it with other Mi users who might be struggling too. And remember — always double-check ROM files before flashing to avoid future bricks!
Required :
- Redmi Note 5 Pro with good charge battery
- Redmi Note 5 Pro Flash File (Stock ROM)
- Redmi Note 5 Pro Flash tool
- Redmi Note 5 Pro USB Driver
- Micro USB Cable
- Computer or Laptop
Procedure :
- Download all required files from the above link
- Extract to all in any path
- Now Install Qualcomm USB Driver in your Computer or Laptop (already Installed then SKIP this)
- Now Open Mi Flash tool
- Click on Setting and Select Firmware (Flash File)
- Select Clean all Lock
- Now Put phone on EDL Mode Using Test Point (You can See Test Point in Below Video Link)
- Click on Refresh Button then You can See Port
- After that Click on Flash button
- Wait until completed
0 Comments
Write Your Problem in the Below Comment Box