15 January 2016

Intex Cloud X1 Plus Too many pattern Done!

Posted by
15 January 2016
Sponsored Links

Required for that:

1. Intex Cloud X1 Plus device with good battery charged
2. CS tool you can use other box
3. Micro usb cable
4. Computer or Laptop

Procedure:

1. Open CS Tool
2. Choose Chines Phones
3. Choose SPD (Spreadtrum)
4. Go to Locks / Reset tab
5. Click on Rest Too/many pattern lock
6. Press and hold Boot key and insert usb cable
7. Wait until reset lock device
8. You are done

Intex Cloud X1 Plus Too many pattern Done! screenshot:

Intex Cloud X1 Plus Too many pattern Done! logs:
 1.Remove Battery, Insert usb cable, Insert battery  
 2.power off Phone, Remove & Reinsert Battery , insert USB Cable  
 (bootkey's Volume Down or volume up)  
 Waiting for Phone Usb....  
 Phone found : SPRD U2S Diag (COM18)  
 Connecting...  
 Connected done.  
 sending 1st boot...  
 1st Boot is done.  
 Waiting for Boot init...  
 Done.  
 Switching Baudrate to 115200  
 Sending 2nd Boot...  
 2nd Boot done.  
 Waiting for Boot init...  
 Done.  
 SC Boot Ver : 8810  
 SC Boot Mode : 8810000100005A00  
 Loading CST Boot image to RAM...  
 The CST Boot runs normally.  
 CHIP : 88100001  
 CPU ID: 88100001  
 NAND ID : 009800BAFFFFFFFF  
 NAND Size : 256MB  
 NAND Name: NAND_TC58NYG1S8C  
 Boot Information completed.  
 Reading Locks Location..  
 Reseting Locks.....  
 Reset done  
 [ insert simcard & enter any keys ]  
 Action completed  
 Time taken : 00:01:56  
 Reconnect Battery/USB Cable  
 CS-Tool Ver 1.33  
Sponsored Links

No comments:

Post a Comment

If any problem just write down your message on below comment box