15 January 2016

G-Mobile M9 Too Many Pattern Done!

Posted by
15 January 2016
Sponsored Links


Required for that:

1. G-Mobile M9 device with good battery charged
2. CS tool you can use other box
3. Micro usb cable
4. Computer or Laptop

Procedure:

1. Open CS Tool
2. Choose Chines Phones
3. Choose SPD (Spreadtrum)
4. Go to Locks / Reset tab
5. Click on Rest Too/many pattern lock
6. Press and hold Boot key and insert usb cable
7. Wait until reset lock device
8. You are done

G-Mobile M9 Too Many Pattern Done! screenshot:

G-Mobile M9 Too Many Pattern Done! logs:
 1.Remove Battery, Insert usb cable, Insert battery  
 2.power off Phone, Remove & Reinsert Battery , insert USB Cable  
 (bootkey's Volume Down or volume up)  
 Waiting for Phone Usb....  
 Phone found : SPRD U2S Diag (COM352)  
 Connecting...  
 Connected done.  
 sending 1st boot...  
 1st Boot is done.  
 Waiting for Boot init...  
 Done.  
 Switching Baudrate to 115200  
 Sending 2nd Boot...  
 2nd Boot done.  
 Waiting for Boot init...  
 Done.  
 SC Boot Ver : 8810  
 SC Boot Mode : 8810004000005A00  
 Loading CST Boot image to RAM...  
 The CST Boot runs normally.  
 CHIP : SC8810  
 CPU ID: 88100040  
 NAND ID : 002C00BCFFFFFFFF  
 NAND Size : 512MB  
 NAND Name: NAND_MT29F4G08ABC_2  
 Boot Information completed.  
 Reading Locks Location..  
 Reseting Locks.....  
 Reset done  
 [ insert simcard & enter any keys ]  
 Action completed  
 Time taken : 00:03:57  
 Reconnect Battery/USB Cable  
 CS-Tool Ver 1.33  
Sponsored Links

2 comments:

If any problem just write down your message on below comment box