Samsung Galaxy S26 5G users commonly run into the device freezing at the boot logo and restarting repeatedly, especially after rooting the device. The Flash file (Stock ROM) below is a direct fix for this. This build is made specifically for the Exynos 2600 chipset, so confirm your exact model number (e.g. SM-S942B) before downloading.
One thing worth knowing upfront — a full Odin flash resets the device entirely, so take a backup before you start. Also double-check that the CSC/region code below matches your specific unit; mismatched regions can cause boot or network problems.
Device Overview
| Brand | Samsung |
|---|---|
| Device | Samsung Galaxy S26 5G |
| Model Number | SM-S942B |
| CSC / Region | INS |
| Chipset | Exynos 2600 |
| OS Version | Android 16, up to 7 major Android upgrades, One UI 8.5 |
| Storage Variants | 256GB / 512GB |
| RAM Variants | 12GB |
| Recommended Tool | Odin |
Available Firmware Versions
How to Flash Samsung Galaxy S26 5G Using Odin
- Download the firmware and extract the .zip fully to get the .tar/.tar.md5 file — Odin won't read a zipped folder.
- Install Odin and the Samsung USB driver from the links below, then open Odin.
- Power off the phone, then hold Volume Down + Volume Up and connect the USB cable to boot into Download Mode. Press Volume Up to confirm.
- Connect the phone to your PC using a good-quality USB cable — cheap cables are a common cause of connection drops mid-flash.
- In Odin, click "BL", "AP", "CP", and "CSC" and select the matching files extracted from the firmware package.
- Once the port shows as connected (blue/green "COM" box), hit "Start" and let it run — don't disconnect the phone during this step.
- The phone will reboot on its own once flashing finishes. First boot can take a few minutes longer than usual, so give it time.
Common Flashing Errors and How to Fix Them
"FAIL!" in Odin — usually a wrong CSC/region combination or a corrupted file. Re-download the firmware and confirm the CSC code matches your device.
Phone not detected in Odin — almost always a driver issue. Install the Samsung USB driver from the link below, then re-enter Download Mode and try again.
Stuck at "SW REV CHECK FAIL" — this means you're trying to downgrade the bootloader/binary version, which Samsung blocks by default. Flash a firmware with an equal or higher binary number instead.
Frequently Asked Questions
Is this firmware official?
Yes, these are unmodified stock builds.
Will flashing delete my data?
A full firmware flash (BL+AP+CP+CSC) wipes the device, so back up anything important first.
My model number doesn't match exactly — can I still use this?
Make sure the CSC/region code matches INS exactly, as listed above. Using firmware meant for a different region can leave features like network bands mismatched.
Tools You'll Need
Before flashing, make sure you have Odin and the correct Samsung USB driver installed on your PC — most flashing failures come down to a missing driver or an outdated Odin version rather than the firmware itself.
0 Comments
Write Your Problem in the Below Comment Box