Xiaomi 17 Ultra (nezha) Test Point: Enter EDL Mode 9008

If you are trying to unbrick your Xiaomi 17 Ultra (nezha) or remove an FRP lock but the device is not entering Download Mode, you will need to use the Xiaomi 17 Ultra Test Point. By shorting these hardware pins, you can force the device into 9008 Mode USB Networking or COM port mode for flashing with professional tools.

⚠️ Disclaimer: Opening your device and shorting motherboard pins requires technical skill. This process will void your warranty. Proceed at your own risk. GSM Helpful is not responsible for any hardware damage.

Xiaomi 17 Ultra Test Point Details

Feature	Description
Device Name	Xiaomi 17 Ultra
Model Number	nezha
Chipset	Qualcomm SM8850-AC Snapdragon 8 Elite Gen 5
Purpose	Boot Repair, FRP Reset, Unbricking
Boot Mode	9008 Mode (Test Point)
Tools Required	Pandora Box, Chimera, or UnlockTool

Xiaomi 17 Ultra nezha Motherboard EDL Test Point Pinout for 9008 Mode

Why do you need the Xiaomi 17 Ultra Test Point?

The hardware test point is essential in the following scenarios:

Dead Boot Repair: When the phone is not turning on and not showing anything on the screen.
FRP Bypass: Using professional tools like UnlockTool, Chimera, or Z3X.
Locked Bootloader: When software-based methods to enter Download mode fail.
Wrong Firmware Flash: To recover a device that was flashed with the incorrect binary.

How to Connect Xiaomi 17 Ultra in Test Point Mode

Carefully remove the back cover of your Xiaomi 17 Ultra.
Disconnect the Battery Connector (Safety first).
Locate the two small golden dots (Test Points) on the motherboard (refer to the image above).
Use a pair of metallic tweezers to short (connect) these two dots.
While holding the tweezers on the dots, connect the USB Cable to your PC.
Check your PC's Device Manager. You should see "Samsung Mobile USB Serial Port" or similar under Ports.

Required Drivers

To ensure your PC detects the device, install the official Samsung USB Drivers.

Xiaomi 17 Ultra (nezha)

Conclusion: Once the device is detected in the correct port, you can use your preferred service tool to flash the firmware or reset the device. If you have any questions regarding the pinout location, leave a comment below!