Lenovo K12 Pro (XT-2091-8) Test Point Enter EDL Mode 9008 (Snapdragon 662)

If you are trying to unbrick your Lenovo K12 Pro (XT-2091-8) or remove an FRP lock but the device is not entering Download Mode, you will need to use the Lenovo K12 Pro Test Point. By shorting these hardware pins, you can force the device into 9008 Mode USB Networking or COM port mode for flashing with professional tools.

⚠️ Disclaimer: Opening your device and shorting motherboard pins requires technical skill. This process will void your warranty. Proceed at your own risk. GSM Helpful is not responsible for any hardware damage.

Lenovo K12 Pro Test Point Details

Feature	Description
Device Name	Lenovo K12 Pro
Model Number	XT-2091-8
Chipset	Qualcomm SM6115 Snapdragon 662
Purpose	Boot Repair, FRP Reset, Unbricking
Boot Mode	9008 Mode (Test Point)
Tools Required	Pandora Box, Chimera, or UnlockTool

Lenovo K12 Pro XT-2091-8 Motherboard Test Point Pinout for Qualcomm EDL Mode 9008

Why do you need the Lenovo K12 Pro Test Point?

The hardware test point is essential in the following scenarios:

Dead Boot Repair: When the phone is not turning on and not showing anything on the screen.
FRP Bypass: Using professional tools like UnlockTool, Chimera, or Z3X.
Locked Bootloader: When software-based methods to enter Download mode fail.
Wrong Firmware Flash: To recover a device that was flashed with the incorrect binary.

How to Connect Lenovo K12 Pro in Test Point Mode

Carefully remove the back cover of your Lenovo K12 Pro.
Disconnect the Battery Connector (Safety first).
Locate the two small golden dots (Test Points) on the motherboard (refer to the image above).
Use a pair of metallic tweezers to short (connect) these two dots.
While holding the tweezers on the dots, connect the USB Cable to your PC.
Check your PC's Device Manager. You should see "Samsung Mobile USB Serial Port" or similar under Ports.

Required Drivers

To ensure your PC detects the device, install the official Samsung USB Drivers.

Lenovo K12 Pro (XT-2091-8)

Conclusion: Once the device is detected in the correct port, you can use your preferred service tool to flash the firmware or reset the device. If you have any questions regarding the pinout location, leave a comment below!