Infinix Smart 8 Plus (X6526) Test Point | Helio G36 BROM Mode Pinout

If you are trying to unbrick your Infinix Smart 8 Plus (x6526) or remove an FRP lock but the device is not entering Download Mode, you will need to use the Infinix Smart 8 Plus Test Point. By shorting these hardware pins, you can force the device into BROM Mode USB Networking or COM port mode for flashing with professional tools.

⚠️ Disclaimer: Opening your device and shorting motherboard pins requires technical skill. This process will void your warranty. Proceed at your own risk. GSM Helpful is not responsible for any hardware damage.

Infinix Smart 8 Plus Test Point Details

Feature	Description
Device Name	Infinix Smart 8 Plus
Model Number	X6526
Chipset	Mediatek Helio G36
Required Port	MediaTek USB Port (VCOM)
Boot Mode	USB COM 1.0 (Test Point)
Tools Required	SigmaKey, Chimera, UnlockTool, CM2 MT2, Pandora, SP Flash Tool

Why do you need the Infinix Smart 8 Plus Test Point?

The hardware test point is essential in the following scenarios:

• Dead Boot Repair: When the phone is not turning on and not showing anything on the screen.
• FRP Bypass: Using professional tools like UnlockTool, Chimera, or Z3X.
• Locked Bootloader: When software-based methods to enter Download mode fail.
• Wrong Firmware Flash: To recover a device that was flashed with the incorrect binary.

How to Connect Infinix Smart 8 Plus in Test Point Mode

1. Carefully remove the back cover of your Infinix Smart 8 Plus.
2. Disconnect the Battery Connector (Safety first).
3. Locate the two small golden dots (Test Points) on the motherboard (refer to the image above).
4. Use a pair of metallic tweezers to short (connect) these two dots.
5. While holding the tweezers on the dots, connect the USB Cable to your PC.
6. Check your PC's Device Manager. You should see "Samsung Mobile USB Serial Port" or similar under Ports.

Required Drivers

To ensure your PC detects the device, install the official Samsung USB Drivers.

Infinix Smart 8 Plus (x6526)

Conclusion: Once the device is detected in the correct port, you can use your preferred service tool to flash the firmware or reset the device. If you have any questions regarding the pinout location, leave a comment below!