Monday, May 05, 2025

How to Find EDL Point on Huawei P10 Selfie (BAC-L03) | Test Point Guide

Posted by
Monday, May 05, 2025

The Huawei P10 Selfie, powered by the HiSilicon Kirin 659 chipset, is a popular Android tablet known for its performance and reliability. However, like any device, it can sometimes get stuck, bricked, or locked. In such cases, accessing EDL Mode (Emergency Download Mode) using Test Points can help recover the device.

In this guide, we’ll explain how to locate and use the Huawei P10 Selfie Test Point to boot into EDL mode and perform tasks like firmware flashing, unbricking, or FRP bypass.

📱 What is EDL Mode on Huawei P10 Selfie?

EDL Mode is a low-level boot mode that allows direct communication with the chipset for service-level operations. On Huawei devices with HiSilicon HiSilicon Kirin 659, this mode is essential for:

  • Unbricking a dead device
  • Flashing stock firmware
  • Bypassing FRP lock
  • Restoring the tablet when fastboot or recovery is inaccessible

🔧 How to Enter EDL Mode on Huawei P10 Selfie via Test Points

If your Huawei P10 Selfie is not responding to Fastboot or recovery commands, using the Test Point method is the best way to access EDL mode manually.

⚠️ Warning:

Opening the device and using hardware test points will void your warranty. Only proceed if you're an experienced technician or have professional guidance.

📍 Huawei P10 Selfie Test Point Location (HiSilicon Kirin 659)

To locate the Test Point on the Huawei P10 Selfie motherboard:

  1. Power off the tablet completely.
  2. Remove the back panel carefully.
  3. Disconnect the battery to avoid short circuits.
  4. Look near the main chipset area or below the battery connector for two small gold/copper contact pads — these are the EDL/Test Points.
Close-up image showing the EDL Test Point location on the Huawei P10 Selfie (BAC-L03) motherboard near the camera and chipset section

🧰 Tools You’ll Need

  • Tweezers or jumper wire
  • USB Type-C cable
  • Windows PC with proper USB drivers
  • Huawei/Hisilicon flashing tools (like Hisuite, Huawei USB COM 1.0 loader, etc.)
  • Official Huawei P10 Selfie firmware

🔌 Steps to Boot into EDL Mode Using Test Point

Follow these steps to enter EDL on Huawei P10 Selfie:

  1. Power off the device and open the back cover.
  2. Disconnect the battery connection.
  3. Short the test points using tweezers or wire.
  4. While shorting, connect the tablet to the PC via USB.
  5. Your PC should detect the tablet in USB Download Mode or Huawei USB COM 1.0.

✅ Final Notes

Using the Huawei P10 Selfie Test Point method is one of the most effective ways to unbrick your device or flash the firmware when other modes fail. Make sure to use the correct firmware, reliable tools, and handle the hardware with care.

If you’re not confident with hardware work, it’s best to consult a professional technician to avoid permanent damage.

Sponsored Links

No comments:

Post a Comment

Write Your Problem in the Below Comment Box