Have you accidentally bricked your Mi MIX 2? Don’t worry — you’re not alone. Many users end up in this situation while flashing custom ROMs, rooting, or during software updates. The good news? In most cases, your Mi MIX 2 isn’t truly dead — it can be unbricked and brought back to life.
In this article, we’ll walk you through easy and effective steps to unbrick Mi MIX 2 and get your phone working like new again.
🔍 What Does Mi MIX 2 "Bricked" Mean?
Before we dive into the process, let’s quickly understand what a bricked phone means.
- A soft-brick usually happens when your device gets stuck in a boot loop or freezes at the Mi logo. It’s software-related and easier to fix.
- A hard-brick is more serious — your phone shows no sign of life, doesn’t charge, and isn’t recognized by your computer.
Fortunately, both can be fixed with the right tools and patience.
🧩 Can’t Access Fastboot? Try EDL Mode
If Fastboot mode isn't working, you may need to use EDL (Emergency Download) Mode. This requires additional tools like Test Points or a deep flash cable. It’s a bit technical, so proceed only if you’re confident — or seek help from a technician.
Unbricking your Mi MIX 2 might seem intimidating, but with the right method, it’s totally doable. Just follow the steps carefully, and you’ll likely have your phone working again in under 30 minutes.
If you found this guide helpful, don’t forget to share it with other Mi users who might be struggling too. And remember — always double-check ROM files before flashing to avoid future bricks!
Requisite for Xiaomi Mi MIX 2
- Xiaomi Mi MIX 2 device with good battery charged, do not try with low battery
- Xiaomi Mi MIX 2 Stock ROM Firmware
- Xiaomi Mi MIX 2 Flash Tool
- Xiaomi Mi MIX 2 USB Driver (for Flashing)
- Micro USB Cable with good quality
- Computer or Laptop
Procedure Xiaomi Mi MIX 2
- Download tested ROM or Flash tool from above link (if link not working then write down comment on below comment box)
- Go to Firmware WinRAR and please rename to .tgz, if is .gz or tar
- Extract to desktop both WinRAR (Note : Must your firmware folder in desktop OR C Drive)
- Open C:\XiaoMi\XiaoMiFlash\ and choose XiaoMiFlash.exe file and open it
- Click on Select button and choose chiron_global_images_V9.6.1.0.ODEMIFD_20180612.0000.00_8.0_global_d8feaf2017 extracted firmware
- Choose "clean all and lock" on flash tool option in below see below image
- Open behind cover and check below image EDL Test Point
- Touch to two point from the extractor phone and Insert USB cable then it will be gone on EDL Mode
- If not driver installed then Go to My Computer ➦ Properties ➦ Device Manager ➦ Update driver from above link's driver (check below video)
- Now click on Refresh button in XiaoMiFlash Tool, after you can see COM:10 or other on flash tool
- Tick on clean all and lock (Note : if device cloud lock then you can use this option) otherwise choose another option
- Click on Flash button and wait until finished the process, do not try to unplug while device in flashing mode
- Congratulation you are done
0 Comments
Write Your Problem in the Below Comment Box