19 December 2015

Any SPD SC6531 Read Flash or Read code done

Posted by
19 December 2015
Sponsored Links

Must Read Users:
This tutorial tested by me without any error i was done smoothly, here some impotent topic for that solution because if you don't have issue in that topic then you can't done using this tutorial because first carefully read this full tutorial after following step by step, first of must you have any chines box must be option in that if not then you can't solve that, second must be working well your device usb socket you not working well then you also can't solve that, third must be working pro Series Service Cable (7pin) cable also micro usb cable, if not working well then you can't solve that problem using this tutorial, fourth must be working well your computer or laptop usb port if not working well then you can't done that problem using this tutorial, fifth must be installed SPD driver in your computer or laptop if not install then you can't solve that so that all are very impotent for that solution because if any issue in showing topic then you can't solve that let's go how to solve that using chines box.

Required for that:


  • Any SPD SC6531 CPU device with good working usb socket
  • Volcano box or other chines box (must be option in that)
  • Pro Series Service Cable (7pin) (special cable) or Micro usb cable
  • Computer or Laptop

Procedure:


  • Connect volcano box with your computer or laptop (this tutorial done with volcano)
  • Open Volcano box
  • Go to SPD(Spreadtrum) tab

Procedure for Read Flash:
  • Click on Read Flash option
  • Choose correct Boot : Built-Boot_15(SC6531 only)
  • Click on Auto-detect Pinouts if use Pro Series Service Cable (7pin)
  • Untick on Auto-detect Pinouts if use Micro usb cable
  • Click on Start button
  • Wait until full Read Flash if use pro series service cable (7pin)
  • Press and hold boot key and insert usb cable then click on start button if use micro usb cable
  • You are done from Read Flash
Procedure for Read Code:
  • Click on Unlock code option
  • Choose correct Boot : Built-Boot_15(SC6531 only)
  • Click on Auto-detect Pinouts if use Pro Series Service Cable (7pin)
  • Untick on Auto-detect Pinouts if use Micro usb cable
  • Click on Start button
  • Wait until Read code if asking flash file then select first was read file
  • You are done
SPD SC6531 Read Flash or Read code done with Volcano box Logs:
  Internal version: SPRD3  
  Boot downloaded.  
  Start boot please wait a moment....  
  Spreadtrum Boot Block version 1.2  
  CPU TYPE:SC6531 [65310000]  
  FLASH ID: 00C8006000170000  
  Flash Type:[GD] 25LG64bWL  
  Size:0x800000(8MB)  
  Reading completed.  
  The data has been saved in D:\hasan\SPD SC6531 CPU Read file.bin, size: 8 M.  
  Software has two ways to find password, it may have different results to click button again.  
  Failes to open the file!  
  Screen Lock input order:  
   ¢Ù ¢Ú ¢Û  
   ¢Ü ¢Ý ¢Þ  
   ¢ß ¢à ¢á  
  Software has two ways to find password, it may have different results to click button again.  
  Looking for passwords,please wait...  
  [Phone Lock] 1234  
  [Phone Lock] 6604  
 >>Looking for passwords complete.  

SPD SC6531 Read Flash or Read code done with Volcano box video:

Sponsored Links

No comments:

Post a Comment

If any problem just write down your message on below comment box